Protekt Aire 3000 Features
- Protekt Aire 3000 Pump:
- Low air loss and alternating pressure therapies in one system
- Air flow dial offers custom patient comfort and pressure levels
- Static function for safe and easy patient transfer
- Protekt Aire 3000 Pump preset 10 minute alternating cycle
- Visual low pressure alarm indicates air flow may be compromised
- Mattress & Cover:
- 18 laser holes keeps the patient cool and dry
- Removable, fluid resistant, non-shear, antimicrobial nylon cover
- Pillow top feature prevents head and neck from unnecessary movement during alternating mode
- Optional raised side rails
- Weight Capacity: 350 lbs
Note: This item cannot be returned or exchanged once opened due to hygiene reasons
User Guides
- Proactive Protekt Aire 3000 User Manual
- Protekt Aire 3000 Operation Manual
What to buy with Alternating Air Pressure Mattress
- Drive Hospital Bed Fitted Sheet
- Drive M-Rail Home Bed Assist Handle
- McKesson Extra Full Loft Reusable Bed Pillow
Installation Instruction
- Step 1: Place the mattress flat on the bed frame. The inflation tube should be towards the foot end so that it can be connected to the inflation nozzles on the control unit
- Step 2: You may place a thin cotton sheet over the quilted mattress top cover
- Step 3: Hang the control unit over the frame or board at the foot end of the bed using the hooks attached to the control unit. Make sure the control unit is secured
- Step 4: Connect the inflation tubes from the mattress to the control unit’s inflating nozzles. Make sure they are properly attached.
NOTE – Make sure the air hoses are not kinked or tucked under the mattress. Also check to ensure the CPR valves are properly attached - Step 5: Plug the power cord into an electrical outlet with grounded AC power. This product should be grounded. The power cord has a grounding wire with a grounding pin.
NOTE – Before inserting the plug into the outlet, make sure the voltage is compatible. Also make sure this product is well grounded - Step 6: Turn on the power by pressing the power switch on the control unit.
Cleaning Guidelines
- Use a neutral detergent to clean surface of control unit and mattress; disinfectant products may be used according to the manufacturer’s protocol. Do not use phenolics on this product
- Do not immerse the control unit in water
- Do not heat or steam in autoclave
- Be sure to fully air dry the mattress and cover after cleaning and before use
- After using for some time (~ 3 months), clean the air filter cotton inside the enclosure base, steps as below:
- Take out air filter cover and air filter cotton
- Wash air filter cotton with clean water, if the dirt sticks to the filter, soak the air filter cotton in the water
- Dry the air filter cotton then put it back to the air filter cover
