What to buy with Ez-Access Ramp Hanger?
- Ez-Access Transitions Modular Entry Mat Riser
- Harmar Vehicle Wiring Harness
- Ez-Access Suitcase Signature Series Ramp
How to Install Ez-Access Ramp on Platforms?
- Locate MRHP. Install two hangers onto the side of the platform where the ramp will be attached.
- Hold the hanger perpendicular to the platform side rail then bring the hanger upward until it is against the side rail lip. Rotate the hanger and continue pushing upward in such a manner that the “hook” at the top of the hanger goes behind and catches on the lip at the top of the platform side rail and the hanger sits on the ledge at the bottom.
- Set the ramp on the hangers. The hangers should be positioned as close as possible to the ramp side rails. The procedure is the same at both the top and bottom of ramp runs which end at a platform unless a transition plate is used.
WARNING: Do not attempt to walk on ramps until installation is complete.
Securing Ramps to Platforms
- After all ramps and platforms have been positioned and all handrails and/or connectors, and end loops have been installed, ramps must be secured to platforms with clips
- Use two clips at all locations where a ramp meets a platform.
- Position the clip so that the long side is as close as possible and parallel to the ramp side rail with the clip edge extending onto the ramp side rail by approximately 5/16″
- Drill 1/8″ pilot holes centered on the ramp side rails and 5/16″ from the edge of the platform side rail then use the 1/4″ x 1″ long self-drilling, self-tapping screws to secure the clip to the platform side rail.
